[ Instructions, Part 1 ] [ Instructions, Part 2 ] [ Instructions, Part 3 ]
[ Fig. 1 ] [ Fig. 2 ] [ Fig. 3 ] [ Fig. 3-T ] [ Fig. 4 ] [ Fig. 5 ] [ Fig. 5-T ] [ Fig. 6 ] [ Fig. 7 ]
[ Fig. 8 ] [ Fig. 9 ] [ Fig. 10 ] [ Fig. 11 ] [ Fig. 12 ] [ Fig. 13 ] [ Fig. 14 ] [ Fig. 15 ]
INSTRUCTIONS - Part Two:
There will be one Type A and one Type B Cross-member Bracket at the top of each Corner Post (as in Figure 8). There will be one Type B Cross-member Bracket at the bottom of each Front Corner Post to attach the Bottom Front Cross-member (as in Figure 9).
Be sure that the wide (Type A) Cross-member Brackets are mounted on the wide side of the Corner Posts.
 |
NOTE: the cross-members and panels shown in the figures are NOT assembled to the corner posts at this time. |
Nail Galvanized Corner Brackets to the insides of the Corner Posts 3 1/2" from the top as shown in Figure 10.
These will aid in assembling the Succah by supporting the Cross-members while bolting them to the Cross-member Brackets.
Nail the 16" Back Panel Braces to the Rear Corner Posts using 3" common nails as shown in Figure 11 and Figure 12. Drill 1/8" pilots holes before nailing to prevent Corner Posts from splitting.
The bottom end of the Brace should be 1" above the bottom of the Corner Post. The Brace should be mounted perpendicular to, and flush with, the back edge of the Corner Post.
Line up the left end of the Back Panel with the Back Panel Brace on the Left Rear Corner Post. Using the Back Panel as a template, drill through the holes in the Back Panel to make corresponding holes in the Back Panel Brace as shown in Figure 11 and Figure 12.
Repeat with the right end of the Back Panel and the Right Rear Corner Post.
Line up the rear end of the Right Side Panel with the Right Rear Corner Post, level with and perpendicular to the Back Panel Brace. Using the Side Panel as a template, drill through the holes in the Right Side Panel to make corresponding holes in the Corner Post as shown in Figure 11 and Figure 12.
Repeat with the rear end of the Left Side Panel and the Left Rear Corner Post.
Line up the front end of the Left Side Panel against the wide side of the Left Front Corner Post. Be sure the bottom edge of the Side Panel is 1" from the bottom of the Corner Post. Using the Side Panel as a template, drill through the holes in the Side Panel to make corresponding holes in the Corner Post.
Repeat with the front end of the Right Side Panel and the Right Front Corner Post.